Grove - Uart Wifi

MEPA CODE: 013311416
BRAND: Seeed Technology Co
MANUFACTURER CODE: 113020010
SKU CODE: SE-113020010
Availability: Unavailable Availability (legend)
21,55 € (excl. VAT)
Full description

This product is retired, please consider the new version Grove - UART WiFi V2.


Grove - UART WiFi is a serial transceiver module featuring the ubiquitous ESP8266 IoT SoC. With integrated TCP/IP protocol stack, this module lets your microcontroller interact with WiFi networks with only a few lines of code. Each ESP8266 module comes pre-programmed with an AT command set firmware, meaning you can send simple text commands to control the device. The SoC features integrated WEP, WPA/WPA2, TKIP, AES, and WAPI engines, can act as an access point with DHCP, can join existing WiFi networks and has configurable MAC and IP addresses.

 

Features

  • Grove 4-pin connector (RX,TX,VCC,GND)

  • 802.11 b/g/n protocol (2.4GHz)

  • WiFi Direct (P2P), soft-AP

  • Supports three modes: AP, STA and AP+STA coexistence mode

  • Integrated TCP/IP protocol stack

  • LwIP (lightweight IP)

  • Integrated low power 32-bit CPU could be reprogrammed as an application processor

  • Integrated temperature sensor

  • Serial UART Interface

  • Multi-queue QoS management

  • Wake up and transmit packets in < 2ms

  • Metal shielding

  • Onboard ceramic antenna

  • Reset switch

 

Specification

  • Input voltage: 3V / 5V

  • Baud Rate: 115200

  • Based on ESP8266 ESP-07 SoC

  • AT Firmware: esp_iot_sdk_v1.1.0 + Seeed modifications:

  • 2x additional AT commands to control blue Link LED.

  • Register red WiFi LED to the ESP8266 wifi state LED.

  • AT command set

  • SDIO 1.1/2.0, SPI, UART

  • Five power states: OFF, DEEP_SLEEP, SLEEP, WAKEUP and ON.

  • Standby power consumption of < 1.0mW (DTIM=3)

  • Integrated TR switch, balun, LNA, power amplifier and matching network

  • Integrated PLLs, regulators, DCXO and power management units

  • +19.5dBm output power in 802.11b mode

  • Power down leakage current of