Grove - Uart Wifi
This product is retired, please consider the new version Grove - UART WiFi V2.
Grove - UART WiFi is a serial transceiver module featuring the ubiquitous ESP8266 IoT SoC. With integrated TCP/IP protocol stack, this module lets your microcontroller interact with WiFi networks with only a few lines of code. Each ESP8266 module comes pre-programmed with an AT command set firmware, meaning you can send simple text commands to control the device. The SoC features integrated WEP, WPA/WPA2, TKIP, AES, and WAPI engines, can act as an access point with DHCP, can join existing WiFi networks and has configurable MAC and IP addresses.
Features
-
Grove 4-pin connector (RX,TX,VCC,GND)
-
802.11 b/g/n protocol (2.4GHz)
-
WiFi Direct (P2P), soft-AP
-
Supports three modes: AP, STA and AP+STA coexistence mode
-
Integrated TCP/IP protocol stack
-
LwIP (lightweight IP)
-
Integrated low power 32-bit CPU could be reprogrammed as an application processor
-
Integrated temperature sensor
-
Serial UART Interface
-
Multi-queue QoS management
-
Wake up and transmit packets in < 2ms
-
Metal shielding
-
Onboard ceramic antenna
-
Reset switch
Specification
-
Input voltage: 3V / 5V
-
Baud Rate: 115200
-
Based on ESP8266 ESP-07 SoC
-
AT Firmware: esp_iot_sdk_v1.1.0 + Seeed modifications:
-
2x additional AT commands to control blue Link LED.
-
Register red WiFi LED to the ESP8266 wifi state LED.
-
AT command set
-
SDIO 1.1/2.0, SPI, UART
-
Five power states: OFF, DEEP_SLEEP, SLEEP, WAKEUP and ON.
-
Standby power consumption of < 1.0mW (DTIM=3)
-
Integrated TR switch, balun, LNA, power amplifier and matching network
-
Integrated PLLs, regulators, DCXO and power management units
-
+19.5dBm output power in 802.11b mode
-
Power down leakage current of
EN